


Hunza Arch Wall Square Light Retro - Powder Coat - Mains

Pay in 3 with Klarna
Rated five stars by thousands of customers since 2014 - see our full review history here
A Mains Wall Light With the Driver Built Into the Cube
The Retro version of the Hunza Arch Wall Square has its driver supplied and installed inside the fitting, so it connects to the mains without a separate driver or remote box. The built in driver is 0 to 10V dimmable. The body is a 150mm by 100mm by 100mm cube of powder coated aluminium that fixes flat to the wall. It is the simplest Arch wall light to wire, and Hunza describes the range as extremely low glare with precise light placement.
Nine Powder Coat Finishes
Pick the finish that suits your wall: Matt Black, Matt Bronze, Matt Dark Grey, Matt Olive Green, Matt Silver Star, Matt White, Matt White Birch, Corten and Fine Silver. The aluminium is a high corrosion resistant alloy with a chromate substrate and a UV resistant polyester powder coat, per Hunza's specification sheet. Colours on screen vary, so ask us for a swatch before you choose a finish. If you would rather use a separate driver, the Series Remote version is the low voltage alternative.
Choose Your Beam and Colour Temperature
Three beams are available. The Long Narrow Beam (Type 2) sends light a long way in a narrow strip. The Forward Throw (Type 4) fans light out in front of the fitting. The Wide Spread (95 Degree) gives a broad, even spread. Choose 2700K for a very warm white, 3000K for warm white or 4000K for a more neutral white.
How It Works
- A Cree CXB 1830 LED board that is field replaceable, giving 3,000 lumens at 700mA from 26 watts, which Hunza lists as 115 lumens per watt delivered.
- CRI is 90 or higher at 3000K, and the LED life is 50,000 hours to L70.
- The driver is integral, supplied and installed. It is a 700mA constant current, 0 to 10V dimmable driver with a mains input of 120 to 277VAC, wired in parallel. The fitting must be earthed.
- An extra clear optical silicone lens and silicone gaskets keep the fitting IP66 rated.
- The cube is 150mm by 100mm by 100mm, fixed to the wall by a plate with four stainless steel screws.
- The warranty is 5 years on the aluminium and 5 years on the electronics, excluding third party lamps and power supplies.
Where It Works Best
- Either side of an entrance or garage door
- On a house wall where you want one fitting and one cable
- Along the face of a garden room or outbuilding
- Beside steps, where a controlled beam keeps glare down
Planning Your Scheme With Us
At Moonlight Design we have worked with Hunza since 2003, designing exterior lighting schemes, supplying Hunza fittings and installing them with NICEIC registered electricians. Photographs of our own finished projects are on the Design Service page, along with how we plan, draw up and fit a scheme.
Good to Know
- Made to order, so please allow 3 to 4 weeks.
- Every Arch fitting is made to order, so it cannot be returned unless it is faulty or damaged.
- The driver is built in, so no separate driver is needed. It is 0 to 10V dimmable. The fitting must be earthed.
- Photographs show the black finish. Every finish is the same shape.
- Hunza also makes DarkSky Approved versions of the Arch range. The DarkSky Approved Luminaire certificates for the range are attached to this page as downloads, and you can ask us about the DarkSky versions.
- We recommend installation by a registered NICEIC electrician.
Questions People Ask
Does the Retro version need a separate driver?
No. The driver is supplied and installed inside the fitting, and the light runs from the mains.
Can it be dimmed?
Yes. The built in driver is 0 to 10V dimmable, so it can be dimmed from a compatible 0 to 10V control.
What mains voltage does it take?
Hunza's specification sheet gives a mains input of 120 to 277VAC.
What colours can I choose?
There are nine finishes: Matt Black, Matt Bronze, Matt Dark Grey, Matt Olive Green, Matt Silver Star, Matt White, Matt White Birch, Corten and Fine Silver. All are powder coated aluminium. Ask us for a swatch before you choose.
How big is it?
The cube is 150mm by 100mm by 100mm, and it fixes to the wall with four stainless steel screws.
Which beam should I choose?
Choose the Long Narrow Beam (Type 2) to light along a path or wall, the Forward Throw (Type 4) to cover a wider area in front of the fitting, or the Wide Spread (95 Degree) for a broad, even spread of light.
Is there a DarkSky Approved version?
Hunza makes DarkSky Approved versions of the Arch range, and the DarkSky certificates are attached to this page. Ask us if you need that version.
We offer free standard delivery on orders within the UK Mainland* (an additional fee applies for the Isle of Wight, the Isle of Man, the Scottish Isles, parts of Scotland, Northern Ireland, the Republic of Ireland, the Channel Isles and International).
*Collingwood orders under £150 incur a delivery fee of £9.95 inc. VAT.
*Any order under £49 incurs a delivery fee of £9.95.

Specifications
What Our Customers Say About Us












