The Garden Zone Elite 6 Wall Spot Light is from the Plug & Go series and uses high powered LEDs.This is a good light for using on either pergolas, fences and walls.
Choose which colour lens you would like from white, red, blue, yellow or green from the drop down menu
Using the 12V plug & go system and high power LED's makes this fitting energy efficient yet easy to use and install.
Material/Colour: Solid Natural Brass
Dimensions: h= 100mm w= 80mm p= 80mm
Light Source: 3 x 1W high power LEDs
IP Rating IP54
Optional 250mm pole extensions for uplighting.
Optional Ground Spike for uplighting.Plug & GoHow it worksStep 1
: Choose the areas you want to have lit then we suggest that you sketch a rough plan view of each area involved.Step 2
: Choose the fittings which will suit the requirements and list them out with the quantity of each where relevant. Be careful to bear in mind the voltage of the fittings chosen. All 240v fittings will need mains supply to wherever they are to be installed whereas all Plug & Go models just need to be connected into the low voltage cable (shown right).Step 3
: Measure the distance involved for the Plug & Go models chosen and determine, from the cable set options available which cable set or sets will be needed. Remember, up to 50 metres of cable can be used from 1 LED driver but the wattage loading must not exceed the recommended minimum, maximum.
Simple Plug & Go connections
Step 4: Plan where the mains supply will originate from. With the Plug & Go system you have a choice of placing the LED driver/drivers in an IP rated wall box on an exterior wall. However, depending on how large an area is involved, sometimes more than one mains feed may be needed in different locations. Consultation with an electrician is advisable on this matter.
The Garden zone Plug & Go fittings use a unique single pin, 2 pole plug and as such are not compatible with any other product or system. Currently they are not dimmable but they will work when wired via a timer.
Maximum run is 80 metres from one driver.
All fittings must be plugged in BEFORE finally switching power on.