Garden Zone Optica 4 Spike Light with Optical Glass Lens GZ/Optica4

Ref: GZ/Optica4

The Garden Zone Optica 4 is a spike light with an optical glass lens which is ideal for use on decks, paths, around patios, low planting, up-lighting etc. The light fitting is from the Plug & Go series and uses high powered LEDs. .

Using the 12V plug & go system and high power LED's makes this fitting energy efficient yet easy to use and install.

Material/Colour: Anodised Aluminium
Dimensions: h= 280mm w= 60mm
Voltage: 12v Plug & Go
Light Source: 3 x 1W High Powered LED
IP Rating IP54

Plug & Go

How it works

Step 1: Choose the areas you want to have lit then we suggest that you sketch a rough plan view of each area involved.

Step 2: Choose the fittings which will suit the requirements and list them out with the quantity of each where relevant. Be careful to bear in mind the voltage of the fittings chosen. All 240v fittings will need mains supply to wherever they are to be installed whereas all Plug & Go models just need to be connected into the low voltage cable (shown right).

Step 3: Measure the distance involved for the Plug & Go models chosen and determine, from the cable set options available which cable set or sets will be needed. Remember, up to 50 metres of cable can be used from 1 LED driver but the wattage loading must not exceed the recommended minimum, maximum.

Simple Plug & Go connections

Step 4: Plan where the mains supply will originate from. With the Plug & Go system you have a choice of placing the LED driver/drivers in an IP rated wall box on an exterior wall. However, depending on how large an area is involved, sometimes more than one mains feed may be needed in different locations. Consultation with an electrician is advisable on this matter.

Important

The Garden zone Plug & Go fittings use a unique single pin, 2 pole plug and as such are not compatible with any other product or system. Currently they are not dimmable but they will work when wired via a timer.

Maximum run is 80 metres from one driver.

All fittings must be plugged in BEFORE finally switching power on.