Moonlight Design Garden Lighting

The Garden Zone Alpha 5 is a spike LED light fitting. This is ideal for naviagtion or highlighting paths. Made from stainless steel offering a modern feel to your garden.

Material/Colour: Stainless steel
Dimensions: h= 340mm w= 75mm,
Voltage: 12v Plug & Go
Light Source: 1 x 1.6W High power LED
IP Rating IP44

Easy to install with the Garden Zone Plug & Go system (please see below for more information).


Plug & Go

How it works

Step 1: Choose the areas you want to have lit then we suggest that you sketch a rough plan view of each area involved.

Step 2: Choose the fittings which will suit the requirements and list them out with the quantity of each where relevant. Be careful to bear in mind the voltage of the fittings chosen. All 240v fittings will need mains supply to wherever they are to be installed whereas all Plug & Go models just need to be connected into the low voltage cable (shown right).

Step 3: Measure the distance involved for the Plug & Go models chosen and determine, from the cable set options available which cable set or sets will be needed. Remember, up to 50 metres of cable can be used from 1 LED driver but the wattage loading must not exceed the recommended minimum, maximum.

Simple Plug & Go connections

Step 4: Plan where the mains supply will originate from. With the Plug & Go system you have a choice of placing the LED driver/drivers in an IP rated wall box on an exterior wall. However, depending on how large an area is involved, sometimes more than one mains feed may be needed in different locations. Consultation with an electrician is advisable on this matter.

Important

The Garden zone Plug & Go fittings use a unique single pin, 2 pole plug and as such are not compatible with any other product or system. Currently they are not dimmable but they will work when wired via a timer.

Maximum run is 80 metres from one driver.

All fittings must be plugged in BEFORE finally switching power on.

Ref: GZ/Alpha5